Extraction Tek

Do You Need to Dry Your Hoses and Fittings After Every Wash?

Connected silicone hoses and pump in Hashtek’s stacking-lines demonstration

Short answer: not if you're washing again in the next day or two. I don't.

Breaking down every hose, pump and fitting after a wash and laying it all out to dry is a lot of work, and in harvest season you are doing it again tomorrow. What I do instead is a habit I picked up in breweries. We called it stacking lines. Canning crews call it packing the line. You clean everything, then leave the system connected and full of sanitizer until the next run.

What stacking lines looks like

Here is the clip that started the question:

Wash is done. I recirculate Star San through the whole system, hoses and pump included, then shut it down and leave it full. Next time I come in, everything is already assembled. I flush it out, rinse with water, and I'm washing.

One thing I'd change about that clip: I mention running it a bit weaker than the label. Don't. Mix it at the label rate, 1 oz per 5 gallons. Star San is cheap and the whole point is that it works.

Clean first. Sanitizer is not a cleaner.

Star San kills what is left after cleaning. It does not remove hash, chlorophyll or plant matter, and anything left in the line is going to sit in there all night. Clean the system the way you always do: rinse out the trichomes and plant material, open any fitting that traps material, scrub the pump head if it needs it. Then sanitize and pack.

If you can't get a part clean without taking it apart, take it apart. Stacking lines is for the parts that are already clean and would just be drying on a rack anyway.

How long can it sit?

Overnight, sometimes a couple of days.

Five Star will tell you to use Star San within an hour of mixing it. Fair enough, that is their claim as a sanitizer and I'm not arguing with it. But that is not the job the packed solution is doing. It's there so the lines don't sit wet and stagnant, which is how you grow biofilm. The sanitizing step is the fresh batch I run through before the next wash. Don't skip that because the lines "already had Star San in them."

Longer than a few days, drain it and dry it. There is no reason to leave a system packed for a week.

Is Star San hard on silicone hoses?

I haven't had a hose go brittle or cloudy on me doing this. That's my experience, not a lab test.

That said, BrewHardware tells its customers not to soak their silicone tubing in Star San for more than a few hours, and says days to a week of soaking can make it brittle. Different hose, different silicone, but it's a fair warning and it lines up with the advice above: a night or two, fine; going on holiday, drain and dry. If you're running someone else's hose or pump, ask them.

Stainless and tri-clamp hardware don't care.

What about the fittings?

Take apart whatever you need to take apart to get it clean. Tri-clamp gaskets are the usual suspect; hash and gunk hide under them. When you do a full teardown, pop the gaskets out, look at them, and replace any that are cracked or flattened.

The question isn't "does every fitting have to come apart every time." It's "is this part clean, and can I see that it's clean, without taking it apart." If yes, leave it on and pack it.

Want a second opinion on your setup? Send me your machine, the hoses and pump you're running, and how long it sits between washes.

Happy Hash Making!

View all articles